I have two maps I'm using and I want them to go to the second map and the z level is set to five and I want them to go to z level 4 but when I try this with
locate(20,19,4)
I get a black screen
ID:165570
Dec 2 2006, 9:46 am
|
|
I feel like a noob asking this but how exactly do you use z levels to switch maps
I have two maps I'm using and I want them to go to the second map and the z level is set to five and I want them to go to z level 4 but when I try this with locate(20,19,4) I get a black screen |
Dec 2 2006, 7:35 pm
|
|
That location does not exist, or nothing exists in that location. Check your map again.
|
In response to CaptFalcon33035
|
|
... yes it does, its on z level 4 at that exact spot
|
In response to KirbyAllStar
|
|
Do you have two different files for maps? the z levels for the maps are alphatized so say
Town(3 z levels) World (2 z levels) if you put (4,6,4), You will go to World's first z level. Hope that helped. |
In response to Tazor07
|
|
ah ok that helped a lot thanks
|